Pages

Friday 17 November 2017

Kates 3D Printing Phone Case




This is my phone case I made on tinkercad. First we had to start with a cube then we had to make it bigger after was the hardest part making the corners round not pointy.
To do this we had to use another cube then we got a cylinder witch we put on the corners (like shown on the picture) then make the cylinder a hole. After we had to put the corner on a corner then make it a hole then, we have a corner, Hooray.
I hope you can try make one.
Kate

No comments:

Post a Comment

Note: only a member of this blog may post a comment.